DYmond DSV

Products that may be inspected:

DYmond DSV has been designed to combine the Dymond S ease of use and the DYmond D high performances level.

The x-ray source, a 500W mono-block, is the same installed on the Dymond 80-120-160-S series, but in this case a wider aperture of the beam is used to illuminate two detectors positioned at a different angle to the products. This configuration allows to increase the contaminants’ probability of detection in the “critical” areas of the containers usually processed with multi-beam systems (bottom, cap, sidewalls) compared to the ones achievable by a single beam machine.

Moreover, the internal components architecture does not require the 1-diameter gap, typical of the two beams systems, allowing a significant saving in terms of investments and required room. Not needing a spacing device and thanks to the optimized power level, also the shielding covers kit is small and simple, comparable to the easy one normally needed in case of a DYmond S, either straight or “chicane” shaped.

Finally yet importantly, the easy mechanical alignment system between conveyor, x-ray source and detector is the same of the Dymond S, allows to shorten the installation time and makes the Dymond DSV a very versatile solution, which can be quickly integrated in any production line.

Total compliance with hygiene/sanitary requirements of the food industry and very simple maintenance mean the machine can be used for long periods without the need for any operations by specialist technicians.
The modular hardware and extensive range of functions available via the software interface make the new DYmondDSV perfect for all customer requirements.